INTRODUCTION

Many titanium alloys have been developed for aerospace applications where mechanical properties are the primary consideration. In industrial applications, however, corrosion resistance is the most important property.

The commercially pure (c.p.) and alloy grades typically used in industrial service are listed in Table 1. Discussion of corrosion resistance in this brochure will be limited to these alloys.

In the following sections, the resistance of titanium to specific environments is discussed followed by an explanation of the types of corrosion that can affect titanium. The principles outlined and the data given should be used, with caution, as a guide for the application of titanium. In many cases, data were obtained in the laboratory. Actual in-plant environments often contain impurities which can exert their own effects. Heat transfer conditions or unanticipated deposited residues can also alter results. Such factors may require in-plant corrosion tests. Corrosion coupons are available from TIMET for laboratory or in- plant testing programs. A tabulation of available general corrosion data is given in the Appendix.

Titanium offers outstanding resistance to a wide variety of environments. In general, TIMETAL Code-12 and 50A Pd extend the usefulness of unalloyed titanium to more severe conditions. TIMETAL 6-4, on the other hand, has somewhat less resistance than unalloyed titanium, but is still outstanding in many environments compared to other structural metals.

Recently, ASTM incorporated a series of new titanium grades containing 0.05% Pd. (See Table 1 below.) These new grades exhibit nearly identical corrosion resistance to the old 0.15% Pd grades, yet offer considerable cost savings. TIMET is pleased to offer these new titanium grades: 16 (TIMETAL 50A 05 Pd), 17 (TIMETAL 35A 05 Pd), and 18 (TIMETAL 3-2.5 05 Pd). Throughout this brochure, wherever information is given regarding Grade 7 (TIMETAL 50A 15 Pd), these new grades may be substituted. As always, this information should only be used as a guideline. TIMET technical representatives should be consulted to assure proper titanium material selection. Additional information concerning these new grades may be obtained from TIMET.

Titanium and its alloys provide excellent resistance to general localized attack under most oxidizing, neutral and inhibited reducing conditions. They also remain passive under mildly reducing conditions, although they may be attacked by strongly reducing or complexing media.

Titanium metal's corrosion resistance is due to a stable, protective, strongly adherent oxide film. This film forms instantly when a fresh surface is exposed to air or moisture. According to Andreeva^(1) the oxide film formed on titanium at room temperature immediately after a clean surface is exposed to air is 12-16 Angstroms thick. After 70 days it is about 50 Angstroms. It continues to grow slowly reaching a thickness of 80-90 Angstroms in 545 days and 250 Angstroms in four years. The film growth is accelerated under strongly oxidizing conditions, such as heating in air, anodic polarization in an electrolyte or exposure to oxidizing agents such as HNO3, C(R)O3, etc.

The composition of this film varies from TiO2 at the surface to Ti2O3, to TiO at the metal interface^(2). Oxidizing conditions promote the formation of TiO2 so that in such environments the film is primarily TiO2. This film is transparent in its normal thin configuration and not detectable by visual means.

A study of the corrosion resistance of titanium is basically a study of the properties of the oxide film. The oxide film on titanium is very stable and is only attacked by a few substances, most notably, hydrofluoric acid. Titanium is capable of healing this film almost instantly in any environment where a trace of moisture or oxygen is present because of its strong affinity for oxygen.

Anhydrous conditions in the absence of a source of oxygen should be avoided since the protective film may not be regenerated if damaged.